|Home||» Products||» Pharmaceutical Machinery||» Ribbon Blender|
Backed by a team of dedicated professionals and experienced workers, we are a prominent manufacturer and exporter of a huge stock of Ribbon Blender. These blenders consist of U-shaped horizontal trough and are widely used in various applications such as dry mixing of free flowing powders requiring low shear force, dry/wet mixing of dense products, low and medium duty applications and mixing of bulk drugs, chemicals and cosmetic powders. We offer our Ribbon Blender at cost effective prices.
High operational fluency
Non corrosive coating
Low power consumption
Ribbon Blenders consist of a U-shaped horizontal trough and a specially designed and fabricated Double Helical Ribbon Shaft rotating within. A ribbon agitator consists of a set of inner and outer helical ribbons. The outer ribbons move the
material from the ends to the center while the inner ribbons move the material from the center to ends. This counter-current action causes good blending. The ribbons rotate at approximately 100 meters per minute and move the materials both radially and laterally to insure thorough blends in short cycle times. Ribbon agitators are used for blends that will be between 40% and 100% of the rated capacity of the blender. An alternate agitator is the paddle design. The paddles are positioned to move materials in opposing lateral directions and radially. The paddle design is normally applied where friable materials are being blended and when batches as small as 25% of the total capacity are going to be mixed in one blender.
Ã¢â¬¢Ribbon design is suitable for dry mixing of free flowing powders requiring low shear force.
Ã¢â¬¢Paddle design for dry/wet mixing of dense products.
Ã¢â¬¢Ribbon design is appropriate for low and medium duty applications, while Paddle design is suitable for heavy duty applications.
Ã¢â¬¢Blending large volumes of dry solids.
Ã¢â¬¢Dry powder to wet phase mixing.
Ã¢â¬¢Mixing of bulk drugs, chemicals, and cosmetic powders.
Ã¢â¬¢Dry Blending of capsule formulations.
Ã¢â¬¢Lubrication of dry granules in large quantity.
Ã¢â¬¢Available in all grades of Carbon Steel and Stainless Steel.
Ã¢â¬¢Less product contact and slow speeds result in low power consumption.
Ã¢â¬¢Simultaneous charging and blending of materials possible due to stationary trough.
Ã¢â¬¢Optional wear resistant liner plates provided for abrasive products.
Ã¢â¬¢Optional PTFE Coated Internals for Food and Sticky material applications.
Ã¢â¬¢Jacketed construction available for steam and cooling applications.
Ã¢â¬¢Can be offered for vacuum application.
Ã¢â¬¢Ribbon and Paddle designs available.
Ã¢â¬¢Available in working capacities of 5 Liters to 25000 Liters.